Mitsubishi FX2N-32DP-IF, User Manual

Page: 13 / 198

Introduction 1
1-1
1. Introduction
The FX
2N
-32DP-IF(-D) Profibus-DP Interface Unit (hereafter called “32DP-IF”) can be used to
connect FX
2N
/FX
0N
series extension blocks/units and special function blocks/units directly to
an existing Profibus-DP network.
The 32DP-IF provides an intelligent slave function for decentralized control applications. Digital
and analog data from a Profibus-DP master CPU (hereafter called “DP-master”) can be sent
and received to/from any of the supported I/O blocks and special function blocks.
1.1 Features of the 32DP-IF
Using the 32DP-IF FX
2N
/FX
0N
series extension blocks/units or special function blocks/units can
exchange data with any DP-master.
• Up to 256 I/O points and/or up to 8 special function blocks can be connected to the 32DP-IF.
However, adjust total control I/O points to 256 or less. See section 1.3.
• The slave address of the 32DP-IF is adjusted by DIP switches. See chapter 6.
• The 32DP-IF can be connected to a Profibus-DP network via a standard 9-pin D-SUB
connector and a shielded twisted pair cable complying with EN50170. Optional glassfiber
adapters are supported by the 32DP-IF and are available from other vendors.
See chapter 3.
• An FX-20P-E or personal computer can be used to monitor the status of the 32DP-IF and
the data exchanged with the Profibus network. For operating instructions of the FX-20P-E or
personal computer, refer to their respective operation manuals and to section 1.3.1. For
device numbers and explanation, refer to Chapter 5. For parameter of 32DP-IF.
FX2N-32DP-IF Profibus-DP Interface Unit