Mitsubishi FX2N-32DP-IF, User Manual

Page: 68 / 198

FX2N-32DP-IF Profibus-DP Interface Unit User Parameter 7
7-4
*4 Type code of special function block is as following table. This code in the parameter must
be written first in the Lower byte and second in the higher byte.
*5 These types do not have a type code inside the special function blocks.
*6 b: This value is number of BFMs that are adjusted by this parameter set.
*7 Number of exchanged BFM for input or output data (n = 0 ~ 32) defines how many words
are reserved for data exchange with the DP-master. The following bytes define the BFM
addresses of those words.
For example K3 K1 K2 K5 defines 3 words of input data, read from BFM #1, BFM #2 and
BFM #5 of the corresponding special function block or written to BFM #1, BFM #2 and
BFM #5.
*8 The format of this parameter byte is “bit 7 = write flag” and “bit 6 ~ bit 0 = BFM address”.
If “bit 7 = ON (1)”, the data of the following two bytes are written to the BFM specified in
bit 6 ~ bit 0. If bit7 = 0, the following two bytes will be ignored. This mechanism is used to
write all parameter data from the GSD file or D200 ~ D299 to the BFM of the special
function block.
Figure 7.2: Order BFM No. for adjusting BFMs
Table 7.3: Type Code of Special Function Blocks
Model
Type Code
Dec. Hex
FX
2N
-4AD K2010 07DA Hex
FX
2N
-4AD-TC K2030 07EE Hex
FX
2N
-4AD-PT K2040 07F8 Hex
FX
2N
-4DA K3020 0BCC Hex
FX
2N
-2AD
*5
K1 0001 Hex
FX
2N
-2DA
*5
FX
0N
-3A
*5
FX
2N
-1HC K4010 0FAA Hex
FX
2N
-1PG K5110 13F6 Hex
FX
2N
-10GM K5310 14BE Hex
FX
2N
-20GM K5210 145A Hex
FX
2N
-32ASI-M K7070 1B9E Hex
FX
2N
-232IF K7030 1B76 Hex
BFM No. for adjusting
Writing flag:
Bit 7 = ON (1): Write to BFM
Bit 7 = OFF (0): Not write to BFM
bit 0 bit 7