Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 284 / 538

Obstacle detection areas
E00647800224
The detection areas of the corner and back
sensors are limited to those shown in the il-
lustration. Moreover, the sensors are unable
to detect low or thin objects or objects near
the front or rear bumper. Thus, make sure to
check the surroundings as you operate the ve-
hicle in a safe manner.
Corner and back sensor loca-
tions
There are eight sensors (A) in the front and
rear bumper.
Detection areas
Depending on whether the vehicle is equip-
ped with a towing bar, you can change the
parking sensors between the standard mode
and the towing bar mode. The towing bar
mode changes the system to exclude the area
in which the towing bar is mounted from the
detection areas.
Vehicles without a towing bar
The detection areas are within approximately
60 cm (A) from the front and corner sensors
and 125 cm (B) from the back sensors.
Vehicles with a towing bar
The detection areas are within approximately
60 cm (A) from the front and corner sensors
and 125 cm (B) from the back sensors. The
non-detection areas (C) are within approxi-
mately 20 cm (D) from the bumper.
NOTE
l The sensors do not detect objects located in
the area directly below or near the bumper.
If the height of an object is lower than the
mounted position of the sensors, the sensors
may not continue detecting it even if they
detected it initially.
For information on how to change the detec-
tion areas, please refer to “Changing the de-
tection areas” on page 6-112.
Parking sensors (Front/Rear)*
6-110
OGKE18E1
Starting and driving
6