Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 53 / 538

The turn-signal lamps blink and the horn (the
siren for vehicles equipped with the interior
alarm sensor) sounds, warning people around
the vehicle of an abnormal condition.
Refer to “Alarm activation” on page 3-29.
NOTE
l
The alarm will resume if unlawful actions
are taken again, even if the alarm has stop-
ped.
System cancellation
It is possible to cancel the system activation
during the system preparation mode or the
system armed mode.
In addition, it is possible to cancel the alarm
once it has been activated.
Refer to “Cancelling the system” on page
3-28, “Cancelling the alarm” on page 3-29.
NOTE
l When lending the vehicle to another person
or allowing the vehicle to be driven by
someone who is unfamiliar with the security
alarm system, be sure to give the person a
proper explanation of the security alarm sys-
tem.
If a person who is unfamiliar with the securi-
ty alarm system accidentally unlocked the
vehicle, causing the alarm to sound, the
alarm would be a nuisance to people nearby.
Changing the security alarm
settings
E00301601453
It is possible to set the security alarm to the
“active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK”
position and then remove the key (ex-
cept for vehicles equipped with the key-
less operation system), or put the opera-
tion mode in OFF (vehicles equipped
with the keyless operation system).
2. Place the lamp switch in the “AUTO”
position, and leave the driver’s door
open.
3. Pull the windscreen wiper and washer
switch towards you and hold it there.
(Since the ignition switch is in the
“LOCK” position or the operation mode
in OFF, washer fluid will not be
sprayed.)
Security alarm system
3-25
OGKE18E1
Locking and unlocking
3