Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 219 / 538

WARNING
l
Do not overly rely on the brake auto hold
system. On a steep slope, depress the
brake pedal firmly because the system
may not hold the vehicle stationary.
l
Never leave the vehicle while it is being
stopped by the brake auto hold system.
When leaving the vehicle, apply the park-
ing brake and move the selector lever to
the “P” (Park) position.
l Do not use the brake auto hold system
when driving on slippery roads. The sys-
tem may not hold the vehicle stationary
and an accident could occur.
NOTE
l While operating the brake auto hold system,
you may hear an operation noise to increase
braking force when the system detected the
movement of the vehicle. This does not indi-
cate a malfunction.
How to use brake auto hold
To turn on brake auto hold
If the brake auto hold switch is pressed while
all of the following conditions are met, the
system will change to the standby state and
the indication lamp (A) on the switch comes
on.
l The ignition switch or the operation
mode is in ON.
l The driver’s seat belt is fastened.
l The driver’s door is closed.
NOTE
l When the brake auto hold system cannot be
used, a buzzer will sound and the following
warning will appear on the information
screen in the multi-information display.
• If this warning appears, confirm that all of
the conditions for system operation are
met and that there is no malfunction in the
system.
NOTE
• If this warning appears, fasten the driver’s
seat belt.
l If any of the following occurs while the sys-
tem is standby state, the brake auto hold sys-
tem will be turned off automatically and the
indication lamp on the switch goes off.
A buzzer will sound and the message will
appear on the information screen in the mul-
ti-information display.
• When the driver’s seat belt is unfastened.
• When the driver’s door is opened.
• When there is a malfunction in the sys-
tem.
Brake auto hold*
6-45
OGKE18E1
Starting and driving
6