Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 247 / 538

NOTE
l
The set speed indication on the display turns
to “---” when the accelerator pedal is de-
pressed. This indication remains as long as
the pedal is in a depressed position.
l
The ACC control at the original set speed re-
sumes as soon as you release the accelerator
pedal. Under certain conditions, however,
the braking control and alarming functions
of the ACC may not work for a short while
after releasing the accelerator pedal.
l Set speed adjustment is impossible while the
accelerator pedal is in a depressed position.
To decrease the set speed
There are two ways to decrease the set speed.
By using the “SET -” switch:
The set speed decreases by 1 km/h (1 mph)
every time you push down the “SET -”
switch while the ACC control is working. If
you hold the switch pushed down, the set
speed decreases in increments of 5 km/h
(3 mph).
NOTE
l There is some time lag between the setting
to a new speed and actually decelerating to
that speed.
l If there is a vehicle in front and your vehicle
is following that vehicle at a speed lower
than the set speed, the set speed alone de-
creases with no actual deceleration taking
place.
l While the ACC system is in the stationary
vehicle hold state, the vehicle speed cannot
be set.
CAUTION
l
The setting speed should be set up the suita-
ble speed according to a situation.
By using the brake pedal:
If you depress the brake pedal while the ACC
control is working, the control is cancelled,
allowing you to decelerate the vehicle.
At the point where the vehicle slows down to
your desired speed, push down the “SET -”
switch; the new speed is then set in the sys-
tem.
NOTE
l The ACC control is cancelled if you depress
the brake pedal and the ACC control does
not resume even when you release the pedal.
Adaptive Cruise Control System (ACC)*
6-73
OGKE18E1
Starting and driving
6