Mitsubishi MOTORS Outlander 2007, Service Manual, Technical Information & Body Repair Manual Data

Page: 97 / 473

PARAME
TER
IDENTIFIC
ATION
(PID) DESCRIPTION COMMON EXAMPLE OF
GENERAL SCAN TOOL
DISPLAY
Completion status of non-continuous monitors this monitoring
cycle: Completion status of non-
continuous
monitors this
monitoring cycle:
Catalyst monitoring CAT_CMPL: YES or NO
Evaporative system status EVAP_CMPL: YES or NO
Oxygen sensor monitoring O2S_CMPL: YES or NO
Oxygen sensor heater monitoring HTR_CMPL: YES or NO
EGR system monitoring EGR_CMPL: YES or NO
42 Control module voltage VPWR: xx.xxx V
43 Absolute Load Value LOAD_ABS: xxx.x%
44 Commanded Equivalence Ratio EQ_RAT: x.xxx
45 Relative Throttle Position TP_R: xxx.x%
46 Ambient air temperature AAT: xxx°C (xxx°F)
47 Absolute Throttle Position B TP_B: xxx.x%
49 Accelerator Pedal Position D APP_D: xxx.x%
4A Accelerator Pedal Position E APP_E: xxx.x%
4C Commanded Throttle Actuator Control TAC_PCT: xxx.x%
Actuator Test Function
The actuator test items are shown in the following
table.
M.U.T.-III SCAN
TOOL DISPLAY
ITEM
NO. INSPECTION ITEM ACTIVATING CONTENT
A/C relay 16 A/C compressor clutch relay The relay turns from OFF to ON
EVAP. emission
purge SOL. valve
10 Evaporative emission purge solenoid The solenoid valve turns from OFF to
ON
EVAP. emission
ventilation SOL.
15 Evaporative emission ventilation
solenoid The solenoid valve turns from OFF to
ON
FUEL PUMP 9 Fuel pump Fuel pump operates
Ignition timing 5
BTDC
11 Basic ignition timing Set to ignition timing adjustment
mode
No. 1 injector 1 Injectors Cut fuel to No. 1 injector
No. 2 injector 2 Cut fuel to No. 2 injector
No. 3 injector 3 Cut fuel to No. 3 injector
/7.6+2146(7'.5;56'//(+
#
10$1#4&&+#)0156+%5