Mitsubishi MOTORS Outlander 2007, Service Manual, Technical Information & Body Repair Manual Data

Page: 337 / 473

OPERATION OF TRANSMITTER SYSTEM OPERATION
Panic alarm
system Panic button Press once (press and hold
for 1 second). Starts the panic alarm (headlights flash and
horn honks for three minutes)
Lock button,
unlock button
or panic button
Press again Stops the panic alarm in progress
KEYLESS ENTRY SYSTEM OPERATION TABLE (AFTER ADJUSTMENT)
OPERATION OF TRANSMITTER OPERATION OF KEYLESS ENTRY SYSTEM
Lock button Press once Lock all doors (including the liftgate)
Unlock button Press once Unlock all doors (including the liftgate)
Panic alarm
system Panic button Press once Starts the panic alarm (headlights flash and
horn honks for three minutes)
Lock button,
unlock button,
trunk button or
panic button Press again Stops the panic alarm in progress
ENCRYPTED CODE
ZC6002540001
ON
OFF
Transmitter lock or unlock button
Data
code
Four data codes are transmitted when a switch is
operated once. The encrypted code for user
identification is a combination of 0 and 1, and more
than 1 million different combinations are available. To
prevent theft by copying signal codes, the data code
includes a rolling code with the encrypted code. The
rolling code changes each time a signal is sent.
RECEIVER
The receiver is incorporated into WCM together with
the receiving antenna. The receiver compares the
signal the antenna received from the transmitter with
the encrypted code registered in it, and when they
coincided, outputs a signal from WCM. By connecting
scan tool MB991958 (M.U.T.-III sub-assembly) to the
data link connector, encrypted codes of up to eight
transmitters can be registered.
FUNCTION FOR CONFIRMING ETACS-ECU (RECEIVER) OUTPUT AND OPERATION
When the ETACS-ECU receives can command from
WCM, the ETACS-ECU outputs LOCK/UNLOCK
signal and informs the driver of the keyless entry
system operation by flashing the light (Answerback).
Using a customization feature, the flashing patterns
for the answerback function can be changed according to the table below. The initial setting at
factory for the answerback function is as follows:
"Hazard warning light: LOCK, Flash once, UNLOCK,
Flash twice/Dome light: LOCK, Flash once, UNLOCK,
Stay on for 15 seconds." Using a customization
feature, the hazard answerback function can be
changed (Refer to P.42C-13).
ITEM OPERATION
DOORS AND LIFTGATE LOCKED DOORS
AND LIFTGATE
UNLOCKED
ETACS-ECU (receiver) Sends lock signal Sends unlock signal
Dome light Flashes once Illuminates for 15 seconds
Turn-signal lights (RH and LH) Flashes once Flashes twice
9+4'.'55%10641./1&7.'9%/
%
5;56'/12'4#6+10