Mitsubishi Electric D75D4, User Manual

Page: 583 / 896

12 - 59
MELSEC-Q
12 CONTROL SUB FUNCTIONS
[2] Control precautions
(1) If the positioning movement direction from the stop position to a new target
position is reversed, stop the operation once and then position to the new
target position. (Refer to Fig. 12.35 (c).)
(2) If a command speed exceeding the speed limit value is set to change the
command speed, the warning "Speed limit value over" (warning code: 501)
will occur, and the new command speed will be the speed limit value.
Also, if the command speed change disables the remaining distance to the
target value from being assured, the warning "Insufficient remaining
distance" (warning code: 509) will occur.
(3) In the following cases, the target position change request is ignored, and the
warning "Target position change not possible" (warning code: 518) will occur.

During interpolation control

A new target position value (address) is outside the software stroke limit
range.

The axis is decelerating to a stop by a stop cause.

While the positioning data whose operation pattern is continuous path
control is executed.
 When the speed change 0 flag ( Md.31 Status: b10) is ON.
(4) When a command speed is changed, the current speed is also changed.
When the next positioning speed uses the current speed in the continuous
positioning, the next positioning operation is carried out at the new speed
value. When the speed is set with the next positioning data, that speed
becomes the current speed and the operation is carried out at the current
speed.
(5) When a target position change request is given during automatic
deceleration in position control, positioning control to a new position is
exercised after the axis has stopped once if the moving direction is reversed.
If the moving direction is not reversed, the axis is accelerated to the
command speed again and positioned to the new position.
(6) If the constant speed status is regained or the output is reversed by a target
position change made while " Md.48 Deceleration start flag" is ON, the
deceleration start flag remains ON. (For details, refer to Section 12.7.8.)
(7) Carrying out the target position change to the ABS linear 1 in degrees may
carry out the positioning to the new target position after the operation
decelerates to stop once, even the movement direction is not is reversed.
POINT
When carrying out the target position change continuously, take an interval of
100ms or longer between the times of the target position changes.
Also, take an interval of 100ms or longer when the speed change and override is
carried out after changing the target position or the target position change is carried
out after the speed change and override.