Chapter 1 Introduction
12
2
Within two minutes, press the WPS button on a WPS-enabled client within range of the Device. The
WPS/WLAN
LED should flash while the Device sets up a WPS connection with the client.
3
The
WPS/WLAN
LED shines green for a successful connection.
1.6 The RESET Button
If you forget your password or cannot access the web configurator, use the
RESET
button at the
back of the device to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously and the user name and password will be reset to the default.
1.6.1 Using the Reset Button
With the
POWER
LED on steady, press the
RESET
button for ten seconds or until the
POWER
LED
begins to blink and then release it. When the
POWER
LED begins to blink, the defaults have been
restored and the device restarts.
1.7 LEDs
(Lights)
The following graphic displays the labels of the LEDs.
Figure 3
LEDs
