Chapter 9 Quality of Service (QoS)
119
The following table describes the labels in this screen.
Table 42
Class Setup: Add/Edit
LABEL
DESCRIPTION
Rule Index
Select the (order) number of this rule.
Class Configuration
Active
Select to enable this classifier.
Ether Type
Select the Ether type (IPv4, IPv6, ARP, or IEEE 802.1Q) to which this rule applies.
Interface
Select whether to apply this class to traffic from the LAN or from the WAN.
To Queue
Select a queue to apply to this class (available when you set
Interface
to
From WAN
).
You should have configured a queue in the
Queue Setup
screen already.
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Select the interface from which the traffic class comes.
Source
IP Address
Select the check box and enter the source IP address in dotted decimal notation. A
blank source IP address means any source IP address.
IP Subnet
Mask
Enter the source subnet mask.
Exclude
Select this option to exclude the packets that match the specified criteria from this
classifier.
Port Range
If you select
TCP
or
UDP
in the
IP Protocol
field, select the check box and enter the
port number(s) of the source.
Exclude
Select this option to exclude the packets that match the specified criteria from this
classifier.
MAC Address
Select the check box and enter the source MAC address of the packet.
MAC Mask
Type the mask for the specified MAC address to determine which bits a packet’s MAC
address should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC address
should match. Enter “0“ for the bits of the matched traffic’s MAC address, which can be
of any hexadecimal characters. For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of
00:13:49:12:34:56 matches this criteria.
Exclude
Select this option to exclude the packets that match the specified criteria from this
classifier.
Destination
