Minolta CF2002, Service Manual

Page: 147 / 298

FrameMaker Ver5.5E(PC) CF3102/CF2002 SWITCHES ON PWBs/TECH. REP. SETTINGS
02.06.05
S-14
Item Purpose Setting/Precautions
Stabilizer
(Stabilizer Mode)
The image stabilization
sequence is carried out with-
out clearing the historical data
of image stabilization control.
When PRT Max Density,
PRT Highlight, and Back-
ground Voltage Margin of
Tech. Rep. mode are
changed.
When the Start key is pressed, the image
stabilization sequence is carried out with
reference to the historical data.
(Reset and Stabilizer Mode)
The image stabilization control
historical data is cleared and
an image stabilization
sequence is carried out.
An abnormal value is
recorded in the historical
data due to a sudden extra-
neous light or other cause.
If any unusual symptom is
noted in gradation and den-
sity even after an image sta-
bilization sequence.
When the Start key is pressed, the histori-
cal data is cleared and image stabilization
sequence is carried out based on the ini-
tial values.
PRT Area
(Top Margin)
To vary the print start position
in the FD direction for each of
different paper types in the 1st
Drawer. • Select the appropriate position on the
paper type setting dial according to the
type of paper loaded in the 1st Drawer
and press the Start key.
• Check the test pattern and adjust so
that the distance between the leading
edge of the paper and the edge of the
pattern falls within the range of 5 mm
±
0.5 mm.
The adjustment range is -3.0 mm to
+3.0 mm (in 0.2-mm increments).
PRT Area
(Left Margin)
To vary the print start position
in the CD direction for each
paper source. • Select the paper source and press the
Start key.
• Check the test pattern and adjust so
that the void amount on the left edge of
the paper falls within the range of 3
±
0.5 mm.
The adjustment range is -3.0 mm to
+3.0 mm (in 0.2-mm increments).