6.10
Recorder Maintenance
6.10.1
Cleaning the Recorder Printhead
If the recorder has been used for a long time, deposits of paper debris may collect on the
printhead, compromising the print quality and shortening the life of the roller. Follow this
procedure to clean the printhead:
1.
Take measures against static electricity such as wearing a Disposable Wrist Strap for the
work.
2.
Open the recorder door and remove the paper.
3.
Gently wipe around the printhead using cotton swabs dampened with alcohol.
4.
After the alcohol has been dried completely, reload the paper and close the recorder
door.
CAUTION:
Do not use anything that may destroy the thermal element.
CAUTION:
Do not add unnecessary force to the thermal head.
6.10.2
Recorder Paper Replacement
The instructions below describe the replacement of recorder paper. Use only recommended
thermal paper. This ensures that the print quality is acceptable and reduces print head wear.
1.
Use the latch at the upper right corner of the recorder door to pull the door open.
2.
Remove the empty paper spool.
3.
Insert a new paper roll so that it fits snugly into its housing and the sensitive side of the
paper faces the print head at the top of the recorder (paper feeding off of the spool from
the bottom).
4.
Pull out approximately 4 inches of paper.
5.
Align the paper across the top of the roller.
6.
Holding the paper in place, close the recorder door.
7.
To ensure that the paper is aligned properly and has not been pinched in the door, pull
the loose edge out a couple of inches. If the paper jams, open the door and return to
step 5.
CAUTION:
Never pull the recorder paper with force when a recording
is in process. Otherwise, it may cause damage to the
recorder.
CAUTION:
Do not leave the recorder door open unless you reload
paper or remove troubles.
6.10.3
Care and Storage of Thermal Chart Paper
Thermal Chart Paper is chemically treated and the permanency of a recording is affected by
storage and handling conditions. These conditions are:
