098-00720-000 Revision B – April, 2016
SyncServer 600 Series User’s Guide
39
Chapter 2 Installing
Unpacking the Unit
Secure all cable screws to their corresponding connectors.
Installation Tools and Equipment
You will need the following tools and equipment to install the SyncServer S6x0:
Standard tool kit
Cable ties, waxed string, or acceptable cable clamps
1 mm² / 16 AWG wire to connect grounding lug to permanent earth ground
One UL listed Ring Lugs for grounding connections
Crimping tool to crimp the ring lug
Shielded cabling of the appropriate impedance required by the specific signal
type for signal wiring (including GNSS)
Mating connectors for terminating signal wiring
ESD wrist strap for installing modules
Fasteners for mounting the equipment in rack
Digital multimeter or standard Voltmeter for verifying ground connections to the
chassis
Unpacking the Unit
The SyncServer S6x0 is packaged to protect them from normal shock, vibration and
handling damage. (Each unit is packaged separately.)
Unpack and inspect the unit as follows:
1. Wear a properly grounded protective wrist strap or other ESD device.
2. Inspect the container for signs of damage. If the container appears to be
damaged, notify both the carrier and your Microsemi distributor. Retain the
shipping container and packing material for the carrier to inspect.
Caution:
To avoid interference, you must consider the
electromagnetic compatibility (EMC) of nearby equipment when you
install the SyncServer S6x0.
Electromagnetic interference can adversely affect the operation of
nearby equipment.
Caution:
To avoid ESD damage to parts that are packaged with the
SyncServer S6x0
, observe the following procedures.
