MICRO-EPSILON 4350006.71, Operating Instructions Manual

Page: 40 / 254

Page 40
Instruction Manual Software
thicknessCONTROL MTS 8201.LLT / 4350006.71
Additive correction
consonant
The result of the thickness measurement is corrected ad-
ditively with this consonant. Thereby differences between
contact and non-contact measurements can be compen-
sated.
Air flushing type
The parameter defines when air purging is used. There
are 4 different types: during calibration, during measure-
ment, permanent and never.
Calibration interval
The parameter defines the time interval between calibra-
tions.
Measurement files
path
Here you can set where the measuring files are to be
saved, for example on the network.
Decimal places
Using this parameter, the user can set the number of
digits after the decimal point that are displayed for the
thickness values.
System of units
This is where the user can select between metric or
imperial measuring systems.
Thickness unit
The user can select from among mm, µm, inch, or mil
depending on the system of units set.
Length unit
The user can select from among mm, µm, inch, or mil
depending on the measuring system set.
Border cut
left/right
The parameters define the left and right border which
is mathematically subtracted from the detected product
width.
Mode
Defines the number of tracks for the view length trend.
After traversing the virtual tracks are calculated here.
Track width
This array defines the width of a track.
The positions of tracks can be defined via the array Position specifications as
follows:
Relative to
target start
The positions are stated relatively to the first edge of the
product. The specification is made in percent whereas
the product width corresponds to 100 % .
Absolute to
traversal start
The positions are stated absolutely to the parking posi-
tion of the traversal unit.
Absolute to
target mid
The positions are stated absolutely to the detected prod-
uct mid.
Absolute to
target edge
The positions are stated absolutely to the product edges
whereas the middle track is defined to product mid.
Number of coexistent
products
The parameter defines the number of products which are
to be measured at the same time.
Tolerance check
Here you can set which values are additionally set to
the tolerance should be checked. The mean value, the
respective thickness values of the tracks and the
fixed track value can be selected.
With the value
limits for partial tolerance
you can define how many measured values in [%] of the
complete crossprofile must be outside the tolerance for
the tolerance check.