page 75
Z589
Round Baler
9.10 WHEELS AND TYRES
Periodically measure the tyre pressure and check that it is correct for the tyre type in use by comparing the
measured pressure value with the ratings in Table 11.5 "Tyre pressure values".
•
Periodically check the tightness of nuts on stud bolts of the wheels and verify that the value is
250 Nm
.
•
Have the wheels and tyres repaired by properly qualified personnel with the right tools.
9.11 TIGHTNESS OF BOLTS
Periodically check the tightness of the fastening bolts and nuts and retighten them as necessary by following the
Table 11.4 "Tightening torques".
•
Check the tightening of all nuts and bolts after the first 3 operating hours.
•
Check the tightening of all nuts and bolts after the first 10 bales made with the brand-new machine.
9.12 WELDING
CAUTION ! FIRE HAZARD.
•
NEVER weld the machine with a bale in the baling chamber.
Before attempting any welding on the baler:
•
Stop the tractor, remove the ignition key and wait until all machine parts stop
completely.
•
Disconnect all electrical and electronic equipment.
•
Turn off the control system.
See Chapter 4.2 "Safety warning". Be careful when welding.
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
