page 113
Z589
Round Baler
10-ET.6.3 CUTTING ASSEMBLY
If the machine is equipped with the cutting blades (Z589-2 only), you can extend and withdraw the blades.
You may extend and withdraw the blades in two ways:
Press the
ON-OFF
button and wait for the data to boot.
When the Home screen is displayed, the
Work
icon will be flashing.
IMPORTANT
!: If the Work icon is not flashing (i.e. not selected),
navigate to the icon by pressing
+
,
-
,
R
and
L
.
Method 1:
Extending the blades
•
Use
OK
and
F2
to select
Other
, then use
-
to select the
Active CUT
item. Confirm with
OK
.
•
Wait for the blades to extend, and the
CUT
message will be displayed on the screen.
•
Visually inspect to confirm that the blades are extended.
Retracting the blades
•
Use
OK
and
F2
to select
Other
, then use
-
to select the
Inactive CUT
item. Confirm with
OK
.
•
The blades will be withdrawn and the
CUT
message will be cleared.
Method 2:
Extending / withdrawing the blades
•
Use
OK
and
F1
to select the
Info
, then use
R
to open the blade status window (Active or Inactive).
•
Use
F2
to switch the blade status and confirm with
OK
.
•
Once the blades have been extended, the
CUT
message will be displayed. (Visually inspect to confirm that
the blades are extended).
•
The blades will be withdrawn and the
CUT
message will be cleared.
If there is a fault, the display will show CUTTING CYCLE ERROR. Follow the instructions in Chapter 12
"Troubleshooting".
The cut-off spacing is:
•
77 mm
If the product is to be cut into longer pieces, some blades need to be removed.
See Chapter 9.9 "Cutting assembly maintenance and adjustment" for more information about adjusting, replacing
and maintaining the blades.
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
