page 45
Z589
Round Baler
8.7.3 CLEARING THE ROTOR (Z589-2 only)
There is too much product jammed between the rotor and the conveyor bottom.
DANGER! Before attempting to do ANYTHING to clear the machine: Stop the tractor engine,
remove the ignition key and wait until all moving machine components stop completely.
•
Turn off the F Bus system.
•
Open the right-hand guard panel and remove the clearing gear crank
M
.
A)
Shift the rotor coupling lever
L
to neutral and insert the clearing gear crank into the gear shaft.
B)
Rotate the crank
M
in the direction opposite to the normal running direction to clear the jammed product from
the machine.
If foreign bodies are present and must be removed (e.g. stones, branches, etc.), put on protective work gloves or
use proper tools.
CAUTION!
Be extremely careful: the rotor working zone is extremely hazardous due to the blades located
therein.
If you need to remove the protective shield, follow Chapter 8.7.2 "Clearing the pickup from the product jammed
between the blades and the protective shield".
Once the gap has been completely cleared, remove the crank
M
and replace it in its stowage holder, then close
the access guard panel.
•
Switch the rotor coupling lever
L
back to drive.
•
Reinstall the protective shield if you have removed it.
•
Once finished, you may restart the PTO.
If the rotor does not run:
•
Verify that the rotor coupling lever
L
is properly shifted.
•
The mechanical transmission shear bolt could be shorn.
Replacement instructions, see Chapter 9.2.2 "Replacing the rotor mechanical safety (Z589-2 only)".
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
