page 90
Z589
Round Baler
10-ET EASYTRONIC CONTROL TERMINAL
10-ET.1 INSTALLATION
Check that the control terminal box delivered with the machine contain the following product parts:
1)
Power supply cable
2)
Control terminal
10-ET.1.1 POWER SUPPLY CABLE
Stop the tractor engine, disconnect the battery common cable, connect the power supply cable to the 12 battery
terminals by connecting the red cable (+) to the positive terminal and the black cable (-) to the negative terminal.
Reconnect the common cable.
DANGER!
Some power supply cables can be brown and blue instead.
The brown cable is positive (+), the blue cable is negative (-).
Route the power supply cable through the tractor to have the COBO connector in a position handy to the operator,
but always in the rear of the tractor.
CAUTION!
•
Mind the correct polarity.
•
Clamp the power supply cable terminals firmly on the tractor battery terminals. Otherwise the
control terminal may not function properly.
Connect the power supply cable
C
to the power supply cable
A
which you have installed on the tractor.
Make sure that the COBO female connector tab on the power supply cable
C
fits the COBO male connector
groove on the power supply cable
A
. This will prevent accidental breaking of the cable connection, resulting in
power outage.
Locate the control terminal in a place within the operator's reach in the tractor cabin.
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
