page 112
Z589
Round Baler
Remove both safety hooks
G
(on the left and right-hand sides) and lift the net box.
•
Make sure that the net runs according to the direction of
movement shown on the sticker in the machine.
•
Route and fasten the net at the bottom of its run and leave
the net end hanging loose.
IMPORTANT!
Once the net has been properly installed, set the net wrapper in its original position by pushing
-
before starting the machine to work.
•
Press
CANC
to exit the program.
•
Lower the net box and secure both safety hooks
G
.
CAUTION!
Be careful when working close to the blade on the wrapper.
IMPORTANT!
Make sure that the cutting assembly is released (i.e. the wrapper must be in the original run
limit position).
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
