page 73
Z589
Round Baler
9.9.2 INSTALLING SHARP OR BLANK KNIVES
Withdraw
the blades before installing the sharp blades or the blank blades. You can withdraw the blade drive
directly with the F Bus control terminal.
See the following Chapters on how to proceed:
•
EasyTronic = 10-ET.6.3 Cutting assembly.
a)
Switch the rotor coupling lever
L
to neutral.
b)
Disengage the blades by switching the lever
M
on the right-hand side of the machine to the
Blades Disengaged
position
(the lever
M
is down).
•
Install the sharp blades or the blank blades into the respective mount slots. You can turn the rotor by hand with
great caution to facilitate installation of the blades. Make sure that all blades are firmly seated.
IMPORTANT!
If the sharp blades or the blank blades are not properly fastened, they may fall into the baling
chamber with the product to be baled.
c)
When finished, engage the blades by shifting the lever
M
to the
Blades Locked
position (the lever
M
is up).
d)
Switch the rotor coupling lever
L
to drive.
Lever M down to BLADES RELEASED
Good seating of blades
Good seating of replacement blades
Lever M lifted to BLADES LOCKED
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
