page 42
Z589
Round Baler
8.5 WRAPPING
The F Bus control system can start and complete the bale wrapping cycle automatically or under manual control.
See the following Chapters for more information about the wrapping stages:
•
10-ET.7 Work stages.
8.6 BALE DISCHARGE
When the bale has been wrapped, F Bus will warn you (with an indication depending on the control terminal type)
to open the gate to release the bale.
CAUTION ! Before opening the gate:
• Make sure that you are parked on a flat ground or, when parking on a slope, the machine gate
is directed down the slope.
•
Remove all persons clear from the direct vicinity of the machine and from behind the gate.
Open the gate with the hydraulic DCV lever of the tractor. Wait until the bale clears the baler and close the gate.
F Bus will notify that the machine is ready for the next work cycle.
If the gate fails to close shut, F Bus will warn you (with an indication depending on the control terminal type).
IMPORTANT!
Do not begin collecting with the gate open or one of its hooks not locked!
Note:
The F Bus control system can be operated with different control terminal types.
All information on specific work operations will be explained depending on the control terminal in use.
See Chapter 10 "F Bus control system" for detailed instructions on how to operate the control terminal.
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
