page 56
Z589
Round Baler
9.4 SCRAPER ADJUSTMENT
IMPORTANT!
Both areas on the machine where the scrapers are installed must always be properly adjusted
and clean.
The machine scrapers are:
1) The dancing roller scraper
2) The bottom roller scraper
CAUTION ! Before attempting any maintenance or adjustment of the scrapers:
•
Stop the machine and wait until all moving machine components stop completely.
•
Stop the tractor engine and remove the ignition key.
IMPORTANT!
When adjusting the distance
D
between the scrape blade and the roller, the scraper blade MUST
NOT touch the roller surface.
9.4.1 DANCING ROLLER SCRAPER
•
Open the baler gate to facilitate the planned actions and lock the gate open with the gate safety lock, see
Chapter 4.5.9 "Gate safety lock".
•
Open both side guard panels of the machine.
•
Loosen the 2 bolts
V
(one on each side) and the stud bolts
C
(one on each side), then adjust the distance
D
between the roller and the scraper blade by slightly tapping the scraper with a hammer:
Distance
D
= 0÷0.5 mm.
•
Once finished adjusting, retighten the 2 bolts
V
and the 2 stud bolts
C
, then verify that the distance
D
has not
been changed by retightening the bolts and the stud bolts.
•
Close the side guard panel of the machine.
•
Make sure that no bystanders are near the machine (otherwise remove them from direct vicinity) and start the
tractor.
•
Release the gate safety lock.
Summary of Contents for Z589
Page 130: ...page 127 Z589 Round Baler...
Page 143: ...page 140 Z589 Round Baler Notes...
Page 144: ...page 141 Z589 Round Baler...
