Mecc Alte ECO-ECP 2, Operating And Maintenance Instructions Manual

Page: 7 / 734

7
ECO-ECP iMANUAL December 2013 Rev. 03
ECO - ECP MANUAL
ENGLISH
No person must wear fluttering clothes (such as scarves, etc.) near
the machine and any garment must be fastened with elastic bands at
its ends.
The generators must never and for no reason run whith following
guards removed:
-) terminals cover
-) front covers
-) fan guards.
During assembling and disassembling operations, hold carefully both
ends of the protection grid as the related material elasticity can be
harmful.
In some machines the regulators are equipped with 3 leds which can
be seen from the outside (as standard equipment on large machines,
as optional equipment on small machines):
Green l ed - correct operation
Yellow led - overload protection on
Red led - low speed protection on.
The generators are noisy (table 25 pag. 44); even if the sound level
is certainly lower than that of the prime motor, they must be installed
in soundproof rooms (room, engine room, etc.) where it is necessary
to wear antinoise protectors.
The generators produce heat proportional to the output.
Therefore, do not touch the generator if you do not wear antiscorch
gloves and, after switching it off, do not touch it until it has cooled
down.
Even if all the machine components are protected, keep away from
the machine.
Do not lean or sit on the generator for whatever reason.
Do not remove the labels for whatever reason; on the contrary, if
necessary, replace them.
DANGER OF SHORT CIRCUIT
The degree of protection of the generator is IP21; therefore it is
made prohibition to use whichever type of hydrocleaner and to spray
liquids over the parts containings electrical components.
In case of replacement of spare parts, use original spare parts only.
For the replacement of worn parts, carefully follow the maintenance
instructions; these operations must be carried out by skilled
technicians.
SAFETY REQUIREMENTS