Maquet Servo-i Adult, User Manual, Page: 153 / 283

151
Servo
…
User´s manual
US edition
Order No: 66 00 261
Infant Adult Universal Options
6
CO CO O
2
Analyzer calibration Analyzer calibration nalyzer calibration alyzer calibration lyzer calibration yzer calibration zer calibration er calibration r calibration calibration calibration alibration libration ibration bration ration ation tion ion on n
Preparation Preparation
1. Insert the CO
2
Analyzer into the module yzer into the module
compartment of the Patient Unit. Patient Unit.
Note: The slots are numbered (1,2,3...) d (1,2,3...)
from top to bottom.
2. Connect the Capnostat sensor to the ect the Capnostat sensor to the
CO
2
Analyzer. zer.
Note: The Capnostat sensor must be warm warm
before calibration can begin. Values
displayed during warm-up have reduced
ced
accuracy. If calibration is needed, the
operator will be notified with a message.
will be notified with a message.
Note: The etCO
2
concentration low ration low alarm
can be permanently silenced (Audio off) o off)
when the message Silence alarm
permanently? is shown.
Important:
• During calibration no CO calibration no CO
2
waveforms or s or
measured CO
2
values will be displayed. played.
• During adapter zero calibration the bration the
adapter must only contain room air.
Calibration /CO Calibration /CO alibration /CO libration /CO ibration /CO bration /CO ration /CO ation /CO tion /CO ion /CO on /CO n /CO /CO /CO CO O
2
Analyzer Servo-i Analyzer Servo-i nalyzer Servo-i alyzer Servo-i lyzer Servo-i yzer Servo-i zer Servo-i er Servo-i r Servo-i Servo-i Servo-i ervo-i rvo-i vo-i o-i -ii