MAGUIRE FLEXBUS Lite, Installation Operation & Maintenance

Page: 72 / 143

72
Alarm and Event Log – Also accessible from the home screen alarm button.
Displays the Alarm and Event Log screen. This screen shows the stored
history of alarms, critical events, power on events, and other events. Press
the upper or lower half of the event display windows to page up or page down.
Alarms can be silenced from this screen. Other options in this screen include:
Print to USB, Clear the Alarm Log and filter to show only critical events.
Communications
Setup > System Configuration > Communications
Blender I.D. Number – Sets the Blender ID number. Enter an identification
number for this particular weigh scale blender. This I.D. number will appear
on all printed reports. If you have more than one unit, this helps to identify
reports. If you are using the MLAN Protocol to automatically gather data, then
each controller must have a unique address. Valid numbers are 000 to 255.
TCP/IP Configuration –
Enable DHCP or set a static IP address, subnet
mask and default gateway.
Modbus Server – Enable or disable Modbus TCP.
MLAN Serial Baud Rate –
Set the baud rate for serial communication (RS-
232 or RS-485).
For more information on how to set communication settings see page
48.
Resets
Setup > System Configuration > Resets
User Settings – Save/Restore Settings – Used for saving or restoring
previously saved parameters. For more information on Saving and Restoring
Settings, see “Saving Parameters in the User Backup Settings” on page 64.
Factory Access – For factory access only.
Restore Factory Defaults –
Restores controller back to Factory Defaults.
Firmware Update –
For updating controller firmware from a firmware file
loaded onto a USB drive. See “Updating Controller Firmware” on page 96.