MAGUIRE FLEXBUS Lite, Installation Operation & Maintenance

Page: 38 / 143

38
RLC last digit is set to zero, (RLC 10000).
The "Regrind" thumbwheel switch is set to 25 percent (025).
The Software logic is as follows:
If material level is high, above the high sensor,
the HIGH sensor is COVERED, (returns NO signal);
Regrind runs at the HIGH setting; 90 percent.
If material level is in the middle, between sensors,
the High sensor is NOT covered, (returns a signal),
the LOW sensor IS covered, (returns NO signal),
Regrind runs at the SETTING; 25 percent.
If material level is low, below the low sensor,
BOTH sensors are NOT covered, (both return a signal),
Regrind runs at the LOW setting; 10 percent.
IF RLC equals 1 to 9 (RLC 10001 to RLC 10009):
All the same rules given above apply, except that the regrind setting does not jump in one
step to a new setting, but, instead, moves slowly to the new setting which acts as a limit.
The usage adjustment is made each cycle by the amount specified by the RLC parameter.
Example: RHL is set to 10 and 90 percent (RHL 09010).
RLC last digit is set to 3 (RLC 10003).
The regrind setting is set to 25 percent (025).
The Software logic is as follows:
If material level rises, goes above the high sensor, the HIGH sensor is COVERED, Regrind
usage will increase 3 percent each cycle up to a high limit of 90 percent.
If material level is in the middle, between sensors, the HIGH sensor is NOT covered, the
LOW sensor IS covered, Regrind usage will change 3 percent each cycle, moving back
toward the regrind SETTING of 25 percent.
If material level drops below the low sensor, BOTH sensors are NOT covered, Regrind
usage will decrease 3 percent each cycle down to a low limit of 10 percent.