MAGUIRE FLEXBUS Lite, Installation Operation & Maintenance

Page: 7 / 143

7
Getting Started – Important!
Safety Notifications and
Safety Hazards Page: 8 HAZARDS exist on this unit.
Read Safety Notifications and Safety Hazards.
Blender Part Identification
Page: 10 Identifying key parts and what they do.
Assembly and Installation
Instructions Page: 12 Assembly and installation instructions.
Wiring Considerations
Page: 16 How to minimize electrical interference.
Model Selection
Page: 17 How to verify and change your model selection. All new
blender controllers are pre-configured with the model from
factory. New, spare or swapped controllers may require a
model change.
Touchscreen Key Parts
Page: 19 Identifying the key parts of the blender controller.
Touchscreen Overview Page: 20
Understanding the Touchscreen home screen.
Mode of Operation
Page: 24 This section selects the general Operating Mode of the
machine (Blender, Dispenser, Totalizer) and sets the Blend
Mode as: Additive are dispensed as a % of Natural or
Materials are a % of Total Batch.
Enable / Disable
Material Type Outputs Page: 25 To "Enable" a component, the TYPE must be selected as:
REGRIND, NATURAL, or ADDITIVE. Each TYPE is
controlled differently by the MATH routines. The controller
must know the material TYPE to know how to dispense the
setting. This is IMPORTANT. Be SURE you
UNDERSTAND this section and Mode of Operation before
operating the blender.
Check Out Procedure Page: 29 Step by step procedure to verify correct assembly.
Load Cell Calibration Page: 32 Load Cells of new blenders are calibrated at the factory.
However shipping or rough handling can create load cell
problems. If weight readings are not correct, you MUST
recalibrate the load cells.
Material Flow Rate
Calibration Page: 33 A flow rate calibration is not necessary because the
blender will learn the flow rate over time however if you
change equipment or material you may want to re-calibrate
the material flow rate.
Normal Operation &
Saving the Configuration Page: 39 How to start the blender and save / restore the
configuration.