MAGUIRE FLEXBUS Lite, Installation Operation & Maintenance

Page: 55 / 143

55
Regrind Control
ROC Regrind % to treat as Natural
ROV Regrind Level Control
RHL High / Low Level Control
Additive Control PTA Additive as a Percent of Total
PAR Percent of Additive to Regrind
Mixer Control MIX Mix Time
JOG Jog Time
MPO Air Drive Mixer Timing
FCV Flow Control Delay Open
Load Cell Limits LCL Load Cell Low
LCH Load Cell High
LCF Load Cell Frequency
LCZ Load Cell Zero
While in one COMPONENT list, press the Next and Previous arrow buttons
(Component 1, Component 2, etc) to jump to the same relative position in the next
list. This allows rapid scanning of like parameters in all component groups.
To change a displayed parameter, use the up/down arrow keys to set a new
number. Cancel will cancel a number entry.
Press the green check mark to save the change.
Red X will exit the sequence at any time.
The purpose of each parameter is explained in detail in the following section.
Navigating and Making Changes to Parameters:
Press Display will prompt for a password. (default: 22222) Then press:
Press
Blender Configuration
Display will show the Device Configuration categories.
Press
Parameters
Display will show the categories of Parameters.
Parameters are divided into 6 categories. Control Times,
Vibration Control, Weight Limits, Components, Regrind
Control, and Mixer Control.
Press
The category that would
contain the parameter you
want to adjust.
Categories will have several parameters indicated by a 3-letter
acronym on the left of the screen.
The Components category will have 12 materials, each with
several controlling parameters or groups of parameters.
Press
The parameter that you
want to adjust.
Display will show 5 digits.
Press the up or down arrows to adjust.
Press To save the parameter adjustment or
press the red X to cancel and exit.