Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 7 / 148

M A G U I R E P R O D U C T S , I N C .
7
W E I G H S C A L E B L E N D E R

SECTION 1 – BLENDER STARTUP
Getting Started
– Important!
Safety Notifications and
Safety Hazards Page: 8 HAZARDS exist on this unit.
Read Safety Notifications and Safety Hazards.
Blender Part Identification
Page: 11 Identifying key parts of the blender and what they do.
Controller Parts Identification
Page: 11 Identifying the key parts of the blender controller.
Setup and Installation Page: 16 Assembly, setup and installation instructions.
Wiring Considerations
Page: 21 How to minimize electrical interference.
Check Out Procedure Page: 23 Step by step procedure to verify correct assembly.
Model Selection
Page: 22 How to verify and change your model selection. All new
blender controllers are pre-configured with the model
from factory. New, spare or swapped controllers may
require a model change.
Settings Mode
Page: 58 Settings Mode as percent-of-natural or percent-of-total.
4088 Standard ONLY (Not available in 12-12).
Sets the blend mode as: Additive are dispensed as a %
of Natural or Materials are a % of Total Batch. See *08.
Load Cell Calibration Page: 26 Load Cells of new blenders are calibrated at the factory.
However shipping or rough handling can create load cell
problems. If weight readings are not correct, you MUST
recalibrate the load cells.
Enable / Disable
Material Type Outputs Page: 28 To "Enable" a component, the TYPE must be selected
as: REGRIND, NATURAL, or ADDITIVE. Each TYPE is
controlled differently by the MATH routines. The
controller must know the material TYPE to know how to
dispense the setting. This is IMPORTANT. Be SURE
you UNDERSTAND this section before operating the
blender.
Material Flow Rate
Calibration Page: 34 A flow rate calibration is not necessary because the
blender will learn the flow rate over time however if you
change equipment or material you may want to re-
calibrate the material flow rate.
Normal Operation &
Saving the Configuration Page: 36 How to start the blender and save / restore the
configuration.
Lockout/Tagout, Cleaning,
Maintenance.
Page: 118
How to Lockout/Tagout, Clean and Maintain your
blender.