Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 46 / 148

M A G U I R E P R O D U C T S , I N C .
46
W E I G H S C A L E B L E N D E R

FEEDER POWER OUTPUTS (receptacles on panel front)
Each outlet puts out 120 volts (240 outside USA) through internal plug-in solid-state relays rated
and fused at 3 amps. These relay outputs are designed to drive motors or other devices
requiring power up to 3 amps each. The LEFT outlet is for component number 5, and the
RIGHT outlet is for component number 6.
Do Not use these outlets to power other devices such
as Ethernet to Serial converters.
PANEL FUSE for processor - 1/2 amp
Fuses power to the circuit board power supply, which includes all solenoid outputs and
solid-state relay outputs.
PANEL FUSE for duplex receptacle - 3 amp
Fuses the common power wire of the duplex receptacle (the color and additive
outputs). Since these outlets are only turned on one at a time, each is protected to the
full 3 amp rating of the fuse.
POWER ON switch
Controls all power to the controller and all outputs. When power is switched off, battery backed-
up RAM preserves all internal totals and parameters. All other functions are reset for normal
start-up when power is restored.
Strobe Light
Beeper Alarm
STROBE LIGHT and BEEPER ALARMS
The Strobe light flashes and the Beeper sounds when a component fails to meter properly.
Alarms begin after a number of retries have occurred, this number determined by the parameter
table (see Parameters, _AL). These alarms can also indicate an out-of-range TARE weight.
This range is set by the TL and TH parameters; above 100 or below -50 grams.