Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 34 / 148

M A G U I R E P R O D U C T S , I N C .
34
W E I G H S C A L E B L E N D E R

Material Flow Rate Calibration
If material is changed or hardware is changed (example: 1/2" auger changed to a 1" auger) and
material meters at a much lower or higher rate than expected, the software may take 10 to 20
cycles to fully adjust. During this time cycles will take longer. The software will SELF ADJUST the
flow rate or a Material Flow Rate Calibration can be done to set the flow rate immediately.
To perform a Material Flow Rate Calibration :
Have the HOPPER LOADED with enough material to run for several cycles without running out.
Have the "STOP END OF CYCLE" and "PAUSE" switches DOWN.
Material Flow Rate Calibration
Press Display will say: ENTER PASSWORD
Press Display will say: PROGRAM
If you are calibrating an auger feeder, operate it briefly to ensure it is fully primed. To do so:
Press
Display will say: OPERATE DEVICES
Press
or
Run until Auger Feeder is dispensing
Press This will empty the Weigh Bin
Now you can CALIBRATE the material. To do so:
Press
Display will say: RATE CALIBRATION
Component: _
Press Component #5 will calibrate itself.
Repeat this two key calibration routine for EACH material that you wish to calibrate. Only
components that have a TYPE selected (not "OFF") will operate.
Each time a dispense will occur, followed by weighing, followed by a dump to empty the weigh
bin.
Press
Display will say: WAITING
YOU ARE NOW READY FOR ACCURATE PRODUCTION BLENDING.