Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 65 / 148

M A G U I R E P R O D U C T S , I N C .
65
W E I G H S C A L E B L E N D E R

Updated software is available from Maguire Products free of charge and can be obtained by
calling our office or visiting us on the web
www.maguire.com .
SELECT COMM. SPEED (Set Baud Rate)
Press (*,9,5) to set the baud rate of the COM port. Options are 1200 baud or 2400 baud. Note:
The default baud rate is 1200. If the baud rate is set to 2400, the G2-SA (if in use will also have
to be set to 2400 baud by installing a jumper pin on an internal board. If you wish to do this,
contact Maguire Products and request the document regarding the G2-SA baud rate. Document
is also available online:
www.maguire.com
USBC Driver Version (WSB 12-12 controllers only, not present in 4088 Standard)
Press (*,9,7) to display the USBC Driver version. Press * to update the driver from the Flash
drive. Press CE to verify the USB driver.
Display Load Cell Raw Signal (counts)
Press (*,9,8) to set flag for RAW-SIGNAL readout in place of gram readout of scale weight.
Power-On will always set this flag to OFF. Use the * key to toggle flag ENABLE or DISABLE.
Press EXIT when done. A raw signal readout is useful to demonstrate the extreme sensitivity of
the load cells. The raw signal readout bypasses the calibration math routine. Load cell function
can be monitored without concern for any improper weight calibration that may have been done.
These functions were explained previously in the MANUAL MODE section:
Enable Weight Calibration of the Load Cells
NOTE: *47 must be disabled to perform a zero or full weight calibration
Press (*,9,9) to set flag to enable Weight Calibration of the Load Cells. In later model controllers
you can specify WSB CAL or LIW CAL. Power On will always set this flag to OFF. This flag must
be ON before the load cell weight calibration keys, ZERO and FULL WT, will function. With ON
flag displayed, press EXIT.