Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 27 / 148

M A G U I R E P R O D U C T S , I N C .
27
W E I G H S C A L E B L E N D E R

FULL WEIGHT CALIBRATION
The full weight calibration must be performed immediately after a zero calibration. While still in program
mode, place the calibration weight into the weigh bin. Use the chart below for the calibration weight required
for your model WSB blender.
Model Calibration Weight Enter this value (use your exact value)
Micro Blender (MB,MB1,MB2) 400.0 grams 04000 Tenths of grams
100 Series (140,140R,140MP,160) 1000.0 grams 10000 Tenths of grams
200 Series (220,240,240R,260) 2000.0 grams 20000 Tenths of grams
400 Series (420,440,440R,460) 4000 grams 04000 Whole grams
900 Series (940,950,960) 9000 grams 09000 Whole grams
1800 Series (1840,1850,1860) 18000 grams 18000 Whole grams
2400 Series (2400) 24000 grams 24000 Whole grams
3000 Series (2400) 30000 grams 30000 Whole grams
Press Display will say: WSB CELL FULL
ENTER WEIGHT: _ _ _ _ _ (5 digits)
Enter the gram value of your calibration weight at this time.
The display will then say: PROGRAM (calibrated weight value)
Full Weight Calibration is complete. Press * 99 and then * twice to DISABLE Calibration Mode.
Press Display will say: CALIBRATION MODE DISABLED
Press
Display will say: CALIBRATION MODE DISABLED
Press Display will say: MODE=BLEND WAITING
Display will show the new calibrated weight value. Remove the
weight from Weigh Bin. The display should go back to displaying
0.0 g. Actual displayed weights may be +/- a few grams.
After a FULL weight calibration, if the display says BAD CELL, the controller is receiving a raw weight reading
from the load cells outside of the expected range. Verify the weigh bin is free to move and that the gram
weigh entered is correct. Verify the correct model is selected. BAD CELL may also indicate the load cells are
bad.