Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 8 / 148

M A G U I R E P R O D U C T S , I N C .
8
W E I G H S C A L E B L E N D E R

Safety Notifications
Electrical Lockout/Tagout Points
Disconnect electric before opening or servicing. If
the weigh scale blender is equipped with an
electrical LOTO box, use the lockout tagout switch
to perform the power lockout/tagout. On 110v
blenders, use a Plug lockout. Read: LOTO,
Cleaning, Maintenance on page 118.
Pneumatic Lockout/Tagout Points
Disconnect compressed air supply before opening or
servicing. If the weigh scale blender is equipped with a
manually operated pneumatic valve actuator, use this
lockout/tagout valve to perform a pneumatic
lockout/tagout.
Read: LOTO, Cleaning, Maintenance
on page 118.
Eye Protection
Always wear safety glasses when using this equipment.
Maximum continuous noise level
The highest continuous Noise levels recorded for this equipment
was measured at 71.4 db.
Safety Interlock Switch
The weigh bin / mix chamber access door may be equipped with a Safety
Interlock Switch that prevents the mix motor from running and the slide valves
from opening. DO NOT disable or bypass this Safety Interlock Switch. Refer to
the motor safety circuits on page 140 for how the safety interlock switch is wired into the
weigh scale blender.
Hopper Finger Guards
Finger Guards are fitted into each Material Hopper compartment.
DO NOT reach through these Guards.
DO NOT use fingers to clear an obstruction below these guards.
DO NOT remove these Guards.
HAZARD - AUTOMATIC STARTUP
WARNING - Blender may start automatically without warning.