Maguire Products WEIGH SCALE BLENDER WSBMB Series, Installation Operation & Maintenance

Page: 69 / 148

M A G U I R E P R O D U C T S , I N C .
69
W E I G H S C A L E B L E N D E R

This parameter will cause your system to PRINT MATERIAL TOTALS automatically. A printer must be
connected.
DLY 00488
CYCLE START DELAY - Delay before cycle start. (Interrupts)
This parameter is the time that the sensor must be uncovered before a cycle will begin.
PRC 00010 MAX. PERCENTAGE CHANGE - Maximum allowable PERCENT rate change per cycle.
This prevents excessive swings in flow rates by the software. Do not change.
STL 00122 DISPENSE SETTLE TIME before a weight reading is taken.
The time (interrupts) allowed for material to SETTLE in the weigh bin before a weight is taken. Lengthen only to
slow the next cycle start, thereby lowering the pile of material in the mix chamber, and, in some cases, improving
mixing.
LCL 00027 LOAD CELL limits, low slope, high slope, frequency, zero.
LCH 00039 DO NOT CHANGE except for different weight load cells.
LCF 00079
LCZ 00583
The above 4 parameters relate to the characteristics of the LOAD CELLS on your blender. DO NOT CHANGE
THEM.
DS1 00000 Thumbwheel switch override setting.
DS2 00000
DS3 00000
The above 3 parameters allow external computer inputs to alter the thumbwheel switch settings. They are used
on computer controlled dispense systems, using MLAN software.
XCV 00000 Extrusion control voltage output value
XRC 00040 Rate of change of above value
TCV 00000 Takeoff control voltage output value
TRC 00040 Rate of change of above value
XTP 05020 Trip point to force a correction
XAL 00005 Percentage adjustment limit
XUL 00200 Voltage adjustment limit
The above 7 parameters all relate to Extrusion Control Systems.
MPO 00000 For air drive reciprocating mix motor
SCR 00000 Special Customer Request
BCR 00000
Barcode Reader
CPL 00000
Yield Control - Counts Per Linear unit of measure
PTD 00020
Pulse Train Delta
MCT 00000
Monitor Cycle Time
LIQ 11011
Liquid Additive - Pump in a Drum (components 10, 11
… one minute retries then switch 10 to 11)
G2F 00000
Alarm status for G2 communications (offline alarm)
XMO 00000
Maximum Extruder Output
LTP 00005
Loss in Weight Trip Point in percent of Batch
LLF 10000
Loss in Weight Low Level Fill
HLF 40000 Loss in Weight High Level Fill (LLF and HLF are set by *22, LIW Model selection)
SBO 00000
Sensor Blow Off for the purpose of clearing dust and particles from the face of the sensor.
RLO 00050 Lowest Dump Rate of Regrind (Grams/Second)
LT1 00000 Loader Timeout #1 (Time in seconds)
LT2 00000 Loader Timeout #2 (Time in seconds)
MDI 00000 MLAN Delay Interval (Time in milliseconds)