Maeda CC423S-1, Operation Manual

Page: 176 / 278

168
3. Stop the engine and remove the starter switch key.
Check that there is nothing around the operator’s seat
and get off the machine.
4. Place the lock lever (1) securely in the lock position (L).
5. Lock the locking cover and caps.
6. Attach a shackle to two locations of the right and left of
the boom and hang a wire rope for slinging.
NOTES
Place padding at points where the wire slinging ropes and
machine body make contact before hoisting.
7. Lift the machine slowly.
NOTES
• Immediately after lifting (dynamic lift off), stop once to
check the sling state and sling posture.
• Check if the posture changes due to leaks of the
hydraulic circuit on the derricking cylinder head side.
• When the machine body is lifted, there is a 0 degree
backwards inclination and an inclination toward the
operator’s seat of approximately 4.0 degrees. The
inclination angle changes slightly depending on the
boom angle and remaining quantity of fuel.