129
4. Operate the right work equipment operation lever (3) to
“RAISE” side (pull toward you) to raise the boom.
5. Repeat the operation in steps 3 and 4 and slowly raise the
boom until the hook block (4) is placed at the position
where it is perpendicular to the stowage section in the
front of the revolving super structure.
If the hook block (4) is detached from the stowage
rope (5) without the boom being raised near the
stowage position, the hook block (4) sways
considerably, which may not only damage the
peripheral equipment but also cause serious
physical injury.
6. Remove the hook block (4) from the rope for stowage (5).
7. Securely hitch the rope for stowage (5) on the rope hook
(6).
NOTES
At this time, be careful not to allow the hook block (4) and
rope for stowage (5) to be overtightened. If the rope for
stowage (5) is overtightened, lower the hook block (4).
Summary of Contents for CC423S-1
