Maeda CC423S-1, Operation Manual

Page: 93 / 278

85
[8] BOOM LOWER LIMIT DETECTION
When the boom length is “3.3 m” or longer, the boom lowering action stops automatically so that the boom
does not fall below the horizontal line.
[9] STATIONARY AND TRAVEL MODE CHANGE DISPLAY
Travel with a lifted load is in principle prohibited because it is very unstable and involves
danger.
When there is no alternative but to perform travelling with hoisted load, refer to “Operation 3.19
Perform Travelling With Hoisted Load” and strictly observe the rated total loads, operation
methods and travel postures for travelling with hoisted load.
Unless these precautions in travelling with a lifted load are observed, serious physical injury
may be caused.
When travelling with a lifted load, use this to change from the
stationary mode to the travel mode.
• Press and hold the switch. The rated load setting changes to
“Travel mode” and the monitor display changes.
• Press and hold this switch again. The rated load setting
changes to “Stationary mode” and the monitor display
changes.
NOTES
When the boom length is “5.1 m” or longer, travel is prohibited
and travel mode cannot be set.
When setting the mode to the travel mode, set the boom length
to “5.0 m” (two stage boom) or less.
2.3.5 MAINTENANCE SWITCH
For details concerning the switch, refer to “Operation 2.2 [5] Maintenance Switch”