99
[2] INSPECTION OF OIL LEVEL AND REFILLING OIL IN ENGINE OIL PAN
As parts and oil are hot immediately after the engine is stopped, there is a risk of burns. Begin
work after the temperature has dropped.
CAUTION
• At the time of inspection, if the machine is found to be tilted, level it before proceeding with
the inspection.
• Check the oil level before the engine is started, or 15 minutes or more after stopping the
engine.
• Be careful not to let any foreign substance go into the filler opening when refilling the oil.
• Keep the engine oil at an appropriate level.
The oil level being too high will result in too much oil consumption and this tends to increase
the oil temperature, deteriorating the oil faster. The oil level being too low may burn out the
engine.
• Be careful not to let any foreign substance go into the filler opening when refilling the oil.
1. Open the engine bonnet.
2. Remove the oil level gauge (G) and wipe off the oil with a
disposable cloth.
3. Insert the oil level gauge (G) again into the gauge guide as
far as it goes and pull it out.
4. If the oil level is between the “H” mark and “L” mark on the
oil level gauge (G), the oil level is acceptable.
If the oil level is lower than the “L” mark, refill the engine oil
from the filler port (F).
5. If the oil level is above the “H” mark, drain excess engine
oil via the drain plug (P) and check the oil level again.
6. If the oil level is acceptable, fully tighten the oil cap and
close the engine bonnet.
Summary of Contents for CC423S-1
