Maeda CC423S-1, Operation Manual

Page: 152 / 278

144
3.19.2 OPERATION POSTURE DURING TRAVELLING HOIST
Retract the boom to “5.0 m” (two-stage boom) or less, work within the “travelling hoist rated
total load” range, and operate with the travelling hoist operating posture. Changing the
operating posture when travelling may cause the machine to tip over, causing serious physical
injury.
When having this machine travel with a hoisted load, take the
travelling hoist posture shown in the right figure.
1. Refer to “Operation 3.15 Boom Telescoping Operation”, and
retract the boom to “5.0 m” (two stage boom) or less.
2. Refer to “Operation 3.13 Hoisting and Lowering” and lower the
hoisted load to as close to the ground as possible.
3. Press and hold the travelling mode selector switch on the
monitor.
The mode is set to the travelling mode and the travelling mark
is displayed on the monitor.
NOTES
• When the boom length is “5.1 m” or longer, travel is
prohibited and travel mode cannot be set.
When setting travelling mode, set the boom length to “5.0 m”
(two-stage boom) or less.
• The travelling operation cannot be performed for safety while
prohibition of travelling is displayed.
• When the travelling lever is operated forward or backward,
the mode is automatically changed to the travelling mode.
However, a priority is given to the setting of the rest/travelling
mode selector switch.