157
5. Operate the starter switch to the “OFF” position to stop
the engine. After that, place the lock lever (1) at the
lock position (L).
6. Remove the fixing bolt (1) to pull out the wedge socket
pin (2), and remove the wedge socket (3).
7. Forcibly twist the end of the wire rope in the direction
opposite to the twisting direction identified in step 1
(the opposite direction to which it will return naturally
when the hand is released from the wedge socket), a
total number of times equal to the hook block twist
number multiplied by “n” (the number of wire rope falls)
and fix in place.
8. Start the engine, shift the right work equipment
operation lever into the “Raise” position (pull inwards),
and raise the boom until the maximum boom derricking
angle is reached.
9. Move the left work equipment operation lever to the
“Extend” position (push forward) to set the boom
length to maximum.
Summary of Contents for CC423S-1
