215026
83
Revision A
4.6
Cutterbar System
1028157
Figure 4.11: R216 SP Cutterbar
Check and change the lubricant at regular intervals. For
instructions, refer to
4.4 Maintenance Requirements, page 76
IMPORTANT:
Warm cold lubricant by idling the machine for 10 minutes prior
to checking level.
4.6.1
Lubricating Cutterbar
Checking and Adding Lubricant in Cutterbar
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Park the machine on level ground.
2.
Lower the header onto 25 cm (10 in.) blocks under both ends of the cutterbar.
3.
Shut down the engine, and remove the key from the ignition.
1028638
A
Figure 4.12: Cutterbar Curtain
4.
Open cutterbar curtain (A). For instructions, refer to
Opening Cutterbar Curtain, page 45
.