215026
26
Revision A
1018911
A
B
C
D
E
F
Figure 3.14: GSL
A - Reel Down
B - Reel Up
C - Header Tilt Down
D - Header Tilt Up
E - Header Down
F - Header Up
9.
Press HEADER DOWN switch (E) on ground speed
lever (GSL) to fully retract header lift cylinders.
10.
Self-Aligning Hydraulic Center-Link:
Press REEL UP
switch (B) on the GSL to raise the center-link until the hook
is above the attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1021743
A
B
Figure 3.15: Header Support
11. Drive the windrower slowly forward until feet (A) enter
supports (B). Continue to drive slowly forward until feet
engage the supports and header nudges forward.
12. Ensure feet (A) are properly engaged in supports (B).
1016903
A
B
C
Figure 3.16: Hydraulic Center-Link
13.
Self-Aligning Hydraulic Center-Link:
a.
Adjust the position of center-link cylinder (A) with the
switches on the GSL until hook (B) is above the header
attachment pin.
IMPORTANT:
Hook release (C) must be down to enable the self-
locking mechanism.
b.
If hook release (C) is open (up), shut down the engine,
and remove the key from the ignition. Manually push
hook release (C) down after the hook engages the
header pin.
c.
Lower center-link (A) onto the header with REEL DOWN
switch on the GSL until the center-link locks into
position and hook release (C) is down.
d.
Check that center-link is locked onto header by
pressing the REEL UP switch on the GSL.