215026
165
Revision A
4.11
Replacing Driveshields
If driveshields are missing, severely damaged, or are not securely installed due to damage, they must be replaced.
4.11.1
Removing Driveshields
CAUTION
To reduce the risk of personal injury, do NOT operate the machine without the driveshields in place and secured.
NOTE:
Images shown in this procedure are for the left driveshield
—
the right driveshield is similar.
1028426
Figure 4.187: Left Driveshield
1.
Open the driveshields. For instructions, refer to
1028552
A
B
C
Figure 4.188: Retaining Pins on Driveshields
2.
Remove bolt (C), retainer pin (B), two washers (A), and a
hex flange center lock nut from the top and bottom of the
outboard half of the driveshield.
3.
Remove bolt (C), retainer pin (B), and the hex flange center
lock nut from the front and rear of the inboard half of the
driveshield.
NOTE:
The inboard half of the driveshield does
NOT
use
washers (A).