![background image](http://html.mh-extra.com/html/macdon/m-series/m-series_unloading-and-assembly-instructions_685706207.webp)
4.4.7
Setting the Rotary Disc Overload Speed
NOTE:
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
• The recommended disc overload speed is 75% of disc speed. For more information refer to the rotary disc
header operator’s manual to determine proper overload speed.
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER
SETUP?
is
displayed
on
the
upper line. NO/YES is displayed on the lower line.
3.
Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figure 4.92: M155 CDM Programming Buttons
Figure 4.93: M205 CDM Programming Buttons
147962
193
Revision A