4.
Press SELECT (C) until TILT CYL INSTALLED? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5.
Press right (B) arrow to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit Programming Mode or
press SELECT (C) to proceed to next WINDROWER
SETUP action.
Figure 4.76: M105 Hydraulic Center-Link
Figure 4.77: M155 Hydraulic Center-Link
4.4.3
Activating the Reel Fore-Aft Function on an M105
NOTE:
Reel fore-aft activation requires installation of the Windrower Optional Hydraulic Fore-Aft Kit (MD #B5577). For
more information, refer to the windrower operator’s manual or the windrower technical manual.
1.
Turn ignition key to RUN, or start the engine. Refer to
.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER
SETUP?
is
displayed
on
the
upper line.
• NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
• SET HEADER TYPE? is displayed on the upper line.
Figure 4.78: CDM Programming Buttons
147962
187
Revision A