MacDon M Series, Unloading And Assembly Instructions

Page: 189 / 396

CAB DISPLAY MODULE (CDM)
CAUTION
Check to be sure all bystanders have cleared the area.
6. Press and hold the HEADER UP (C) button on the
ground speed lever (GSL).
• CALIBRATING HEIGHT is displayed on the
upper line.
• RAISE HEADER HOLD is displayed on the
lower line.
NOTE:
The word HOLD will flash during calibration.
RAISE HEADER DONE will display on the lower
line once calibration is complete.
7. Release the HEADER UP (C) button.
• HEIGHT SENSOR CAL is displayed on the
upper line.
• PRESS LOWER HEADER is displayed on the
lower line.
Figure 4.54: Header Height Controls on Ground
Speed Lever
8. Press and hold HEADER DOWN (A) button on GSL.
NOTE:
The word HOLD will flash during calibration. HT
SENSOR COMPLETE will display on the lower
line once calibration is complete.
9. Release HEADER DOWN (A) button.
• TO CALIBRATE SELECT is displayed on the
upper line.
• HEADER HEIGHT is displayed on the lower line.
10. Press right arrow to select next header sensor
calibration or STOP & EXIT. Press SELECT.
Refer to
4.3.2 Calibrating the Header Tilt Sensor, page
176 or 4.3.3 Calibrating the Header Float Sensors,
page 180 .
11. Press PROGRAM to exit Programming Mode.
Figure 4.55: Header Height Controls on Ground
Speed Lever
147962
175
Revision A