4.
Press SELECT (D) until AUTO RAISE HEIGHT? is
displayed on the upper line.
• Last measurement is displayed on the lower line.
NOTE:
The auto raise height ranges from 4.0 (minimum)
to 9.5 (maximum), in 0.5 increments. A setting of
10 disables the auto raise function.
5.
Press left (B) arrow or right (C) arrow to change
auto-raise height.
6.
Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 4.128: M155 Auto Raise Height
Figure 4.129: M205 Auto Raise Height
4.4.14
Activating the Hay Conditioner
NOTE:
• This procedure is for draper headers only.
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
147962
209
Revision A
