4.4.18
Setting the Engine Intermediate Speed Control (ISC) RPM on an
M105
The ISC sets the engine speed when the header is engaged.
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER
SETUP?
is
displayed
on
the
upper line.
• NO/YES is displayed on the lower line.
3.
Press right (B) arrow to select YES. Press SELECT (C).
• SELECT HEADER TYPE? is displayed on the
upper line.
Figure 4.146: CDM Programming Buttons
4.
Press SELECT (C) until SET ENGINE ISC RPM? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5.
Press right (B) arrow to select YES. Press SELECT (C).
• PRESS HAZARD TO SET is displayed on the
upper line.
• ISC RPM ON is displayed on the lower line.
Figure 4.147: Engine ISC RPM
NOTE:
Previous ISC selection is flashing.
6.
Press right (C) arrow to cycle between ON and OFF.
Press HAZARD (B) to set.
NOTE:
Choosing ON sets the Engine ISC to 2300 rpm.
7.
Press SELECT (D).
• EXIT ENGINE ISC? is displayed on the upper line.
• NO/YES is displayed on the lower line.
8.
Press
right
(C)
arrow
to
select
YES.
Press
SELECT (D).
9.
Press PROGRAM (A) to exit Programming Mode.
Figure 4.148: ISC RPM
147962
217
Revision A
